DFI P35 T2R

[S&M]

We have tested the Transpiper in 3 modes :
First, the system without heatpipes and copper plate.
Then we connected the heatpipe outside of the case, and last thing we
did is to install the copper plate.

All measurements were made with software's measuring the temperatures
and we also used 2 external units – Fluke and UEI.
The system was tested with a Q6600 G0 CPU , at a speed of 3150Mhz,
with 1.5V,North bridge voltage was set to 1.55V and south bridge got
1.45V , and the voltage for the CELLSHOCK PC8000 memory modules was
2.35v, as we wanted to add as much heat as possible to our system.

On our first test, without the Transpiper at all , we got this
temperatures -


Then , we added the Transpiper outside of the case -


As you can see , there is a 3-4 temperatures improvement (around 10%).
Then we added the copper plate to the system , and the results are :


Minimal changes, a one degree change is definitely something that is not a
reason to use it, but maybe with better cooling , like water cooling , it will
produce better cooling results.

* Room temperature during measurements – 27.8 Celsius degrees.